KYOCERA KM-C830D Manuel d'utilisateur télécharger pdf (Page 129)

Section 8 OPTIONAL EQUIPMENT

8-2

IMPORTANT!

• Be sure to set only a number of originals that is LESS than the level

indicator on inside of the rear insert guide. Also, DO NOT set

originals outside the acceptable range as this can cause the

originals to misfeed.

(See page 8-1 for details on acceptable originals.)

• To keep ejected originals from falling off the copier, open the

ejection extension when using larger sized originals such as 8 1/2" x

14" and 11" x 17" [B4 and A3].

• When copying from 2-sided originals, the originals will be

temporarily ejected from the left cover in order to turn them over and

copy the reverse side. Do NOT touch them at this point! Any attempt

to remove them can cause the originals to misfeed.

● Setting originals in the SRDF

Adjust the original insert guides to fit the width of original(s)

to be copied.

NOTES

• Before copying, make sure that there are no originals remaining on

the original eject table. Originals left on the eject table can cause

other originals to misfeed.

• If you are setting multiple originals at one time, ALWAYS use

originals of the same size. It is, however, possible to use different

size originals of the same width (ex.: 11" x 8 1/2" and 11" x 17" [A4

and A3]) at the same time if you use the auto selection mode. See

page 8-3.)

Arrange the originals in order and set them face up (front

side up for 2-sided copies) on the original table. The original

set indicator will light green. If the indicator doesn’t light, set

the originals once again.

1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 160 161

Pas de commentaire

KYOCERA KM-C830D Manuel d'utilisateur Page 129