KYOCERA 1020MFP Guide d'installation télécharger pdf (Page 78)

6-2

Maintenance

General Information

This chapter describes basic maintenance tasks you can perform for the machine. You can replace the toner container

according to the machine's status:

Also, the internal parts need periodic cleaning.

Toner Container Replacement

The Attention indicator identifies the toner status at two stages of toner usage.

• When the machine becomes low on toner, the Attention indicator flashes and a message appears in KYOCERA

Client Tool. Note the replacement is not always necessary at this stage.

• If you ignore the above status and continue printing, E-0007 appears in the display on the operation panel, the

Attention indicator will light up just before the toner is used up and the machine will stop. The toner container must

then be replaced immediately.

In either case, replace the toner container.

Frequency of toner container replacement

According to ISO 19752 and EcoPrint switched off the toner container can print as follows (A4/Letter paper is assumed):

2,500 pages (FS-1020MFP) or 1,600 pages (FS-1220MFP).

You can print a status page to check how much toner remains in the toner container. The Toner Gauge in the consumables

status section on the status page shows a progress bar, which roughly represents how much toner is left in the toner

container.

Starter Toner Container

The toner container packed with the new machine is a starter toner container. The starter toner container lasts an average

of 700 pages.

Toner Kits

For best results, we recommend that you only use genuine Kyocera Parts and Supplies. Should any damage be caused by

the application of a toner other than the original toner, then this damage is excluded from the guarantee.

A new toner kit contains the following items:

• Toner Container

• Plastic waste bag for old toner container

• Installation Guide

Note Information Collection on Memory Chips - The memory chip attached to the toner container is designed to

improve convenience for the end user; to support the recycling operation of empty toner containers; and to gather

information to support new product planning and development. The information gathered is anonymous - it cannot

be associated to any specific individual and the data is intended to be used anonymously.

Note If Non-genuine toner is installed appears in KYOCERA Client Tool after the toner container is replaced, the

installed toner container is non-genuine.

The manufacturer assumes no responsibility for damage caused by a non-genuine toner.

We recommend that you only use genuine toner containers.

When you want to use the toner container currently installed, press the Mode Select key and [Stop/Reset]

simultaneously for 3 seconds or more.

Note Do not remove the toner container from the carton until you are ready to install it in the machine.

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 110 111

Pas de commentaire

KYOCERA 1020MFP Guide d'installation Page 78