Kyocera 1650 Manuel d'utilisateur télécharger pdf (Page 43)

Preparations

2-11

Connecting the Cables

This machine can be connected either to a network or directly to a single computer. This section

describes the procedures to make both types of connection.

Connecting the Network Cable

To connect this machine to a network, use an Ethernet cable (10Base-T or 100Base-TX).

Open the main power switch cover located on the right

side of the machine, turn the main power switch off

({), and remove the power cord from the outlet.

Connect the network cable to the network interface

connector at the right side of the machine.

Connect the other end of the network cable to your network device (hub).

Make network settings. (See page 2-15.)

Connecting the Printer Cable

To connect the machine directly to your computer, use either a parallel cable or a USB cable.

Important! Be sure to turn the main power switch of this machine off before connecting the printer cable.

Open the main power switch cover located on the right

side of the machine, turn the main power switch off

({), and remove the power cord from the outlet. Turn

the power of your computer off.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 139 140

Pas de commentaire

Kyocera 1650 Manuel d'utilisateur Page 43