Kyocera 1650 Manuel d'utilisateur télécharger pdf (Page 85)

Optional Equipment

4-3

Notes • Before setting originals, make sure that there are

no originals remaining on the original eject table.

Originals left on the eject table may cause other

originals to jam.

• When setting multiple originals at one time, be

sure to use originals of the same size. It is,

possible, however to use different size originals of

the same width (for example, 11 × 17" (Ledger)

and 11 × 8

1/2" or A4 and A3 at the same time in

the auto selection mode. (Refer to Chapter 1 in

Advanced Operation Guide, Auto Selection

Mode.)

Arrange the originals in order and set them face up

(front side up for 2-sided originals) on the original table.

Important! • Be sure to set only a number of originals that does

not exceed the level indicator located inside the

rear original insert guide. If you set originals

exceeding the specified number, the originals may

jam. (For the number of originals that can be set,

see page 4-1.)

• To keep ejected originals from falling off the

machine, open the ejection extension when using

large originals such as A3, B4, 11 × 17" (Ledger),

and 8

1/2 × 14" (Legal).

• When copying from 2-sided originals, the originals

are temporarily ejected onto the ejection tray in

order to turn them over. Do not touch them at this

point. Any attempt to remove them may cause the

originals to jam.

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 139 140

Pas de commentaire

Kyocera 1650 Manuel d'utilisateur Page 85