Kyocera 1650 Manuel d'utilisateur télécharger pdf (Page 84)

Optional Equipment

4-2

Notes on Use

Be sure not to use the following as originals in the document processor. In addition, originals with

punched holes or perforations should be set so that the edge of the paper with the holes or

perforations is facing away from the direction of insertion into the document processor.

• Transparencies

• Carbon paper, crumpled originals or originals with strong folds, and soft originals such as vinyl

• Originals which are not rectangular, wet originals, and originals with adhesive tape or glue

• Originals with clips or staples (To use such originals, remove the clips or staples and straighten

any crumples or folds before using them.)

• Clippings or originals with very slippery surfaces

• Originals with wet correction fluid

• Originals with folds (If you must use such originals, smooth out the folded portions before

setting them in the document processor.)

• Curled originals (If you must use such originals, smooth out the curled portions before setting

them in the document processor.)

Important! When moving this machine, be sure to close the document processor.

Names of Parts

1 Original table — Set originals to be copied

on this table.

2 Original insert guides — Adjust these

guides to the width of the originals to be

copied.

3 Left cover — Open this cover if an original

jam occurs.

4 Original eject table — Originals that have

been copied are ejected and stored here.

5 Ejection extension — Open this extension

when using large originals such as A3, B4,

11 × 17" (Ledger), and 8

1/2 × 14" (Legal).

6 Document processor release grip — Hold

this grip to open or close the document

processor.

7 Ejection tray — In the case of two-sided originals, the originals will be temporarily ejected

here.

Setting Originals in the Document Processor

Adjust the original insert guides to the width of original

to be copied.

212354

7 6

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 139 140

Pas de commentaire

Kyocera 1650 Manuel d'utilisateur Page 84